Handbag Knowledge

Handbags are very familiar with everyone in the handbag factory, especially for every sewing worker in the workshop. But how to improve every process and self check to improve our quality?

Handbags are very familiar with everyone in the handbag factory, especially for every sewing worker in the workshop. But how to do every process well and improve the quality of car self inspection? Now I'll take a backpack to show you the basic quality problems and requirements in some processes.

1. license plate: in general, at the bottom of the card, when the needle is gathered, the 3-4 stitches should be weighed. The stitches should be 8-9 inches.

2. pull the bone: the mouth should be uniform, the corners should not be wrinkled, and the four corners should be tightly wrapped around the bone so that the broken bones can not be broken.

3. front loading bag: cover the front pin hole and start the needle in the center of the head or bottom. The four corners of the bags should be parallel and symmetrical.

4. upper chain: the mouth should be uniform, uniform and pay special attention to the direction of the upper zipper.

The chain sticker that comes out of the car must not be able to wave.

5. refute: if you want to adjust the zipper of the car, you can not burst the double lane. It should be uniform and straight.

The effect of barge will directly affect the quality of burying bags.

Too long or too short will cause the buried bag to be crooked or wrinkled. In principle, we must bury the bag before the line is broken.

6. car magic stickers: the line is unified to the side of the hook, and the edges are parallel and not skewed.

7. double back edge wrapping: the edges of the edges should not have big and thin edges, and the discount must be round.

8. mounting head: balance the needle position vehicle, do not skew the line straight, and the mouth is even.

9. side loading bag: pay attention to the direction of pulling the head. When pulling the zipper, pull the head in the direction of the front, the bag should be four square upright, parallel to the top and bottom.

10. car straps: pay special attention to the Quartet card and the center line. Under normal circumstances, the four party card length is 1.5 inches. The middle line must pass through the intersection point, and it can not be bent.

11. car triangular ribbon: generally do not play the four party card ribbon into the triangular material half inch, to play the square card ribbon into the triangular material 1 inches, especially with the guests request.

In fact, it is not very difficult to do well in every process. The most important thing is that we should know its key points.

For example, the requirement of a handbag open line is that the mouth is even and the line is smooth. After doing this, the accessories are parallel and symmetrical, which are also the foundation for making good handbags.

It is the pursuit of our handbag producers to grasp the quality of every process from the beginning of every process.